It is set up on bypass firmware 85.12 and remote start firmware 1.26. I reflashed each firmware to the module in pro mode just be sure then reflashed the settings. It is set to the defaults with the wizard but I did switch to pro mode at one point to verify a few of the settings that were mentioned in the guide, A11 C1 and D2. Once I bring it to the car and plug in holding the button, blue led comes on and then I plug in 3 other cables (THAR-ONE-MAZ3 cable). I press ignition twice, it just cycles through the leds over and over. I've waited at least 2 minutes and it never stops cycling. I tried to read the voltage on the CAN BUS and it was 0.8-1.3V DC while this was going on. Any other things I can try to get the Dcrypt done? Thank you!